What does SMT First tester mean for the company

What is the significance of SMT first tester for enterprises

In today's society, all kinds of electrical appliances are filled in all aspects of our lives, and people are increasingly relying on these electronic products, especially digital products and smart phones, which are a typical example. The production of these products cannot be separated from the core component - the circuit board. Because the demand for electrical appliances continues to rise, the production of PCB SMT electronics factory also continues to increase. The increase of production enterprises will inevitably bring greater competitive pressure, and only in the hands of many competitors, can enterprises survive and grow.

In today's increasing competition, the rapid development of an enterprise cannot be separated from efficient work efficiency, that is, the work efficiency of employees can not be ignored. And an important factor that affects the work efficiency of employees is the quality of equipment. This requires enterprises to pay a certain cost to buy equipment. For example, the emerging SMT first tester, many companies do not think there is a need to buy, because only manual can complete the work, and then pay an additional cost is not cost-effective. However, as long as you understand this product in detail, you can know that the benefits that SMT intelligent first part tester can bring to the enterprise are in all aspects.

smt first tester company

First, the SMT first tester only needs one inspector to operate, the enterprise saves labor costs, and the operation of the SMT first tester is not complicated, and the inspector can quickly get familiar with it;

Second, the speed of the first detection is improved, and the average detection of a component can be 3 seconds, further speeding up the production progress;

Third, the high accuracy of the first detection can find the problem as early as possible, so as to solve the problem;

Fourthly, the detection report is automatically generated, and the report is paperless to avoid accidents in data preservation. At the same time, standardized reports can bring better reading experience and enhance customers' impression of enterprise management;

Fifth, the first detector can be connected with the enterprise's current ERP or MES system.

In traditional SMT first detection, inspectors are often only equipped with multimeters, capacitance meters, magnifying glasses, and such simple equipment can be used in the case of fewer components, but once there are slightly more components, because of the limitations of the equipment, the energy of the staff is limited, and the difficulty of detection increases sharply. In the case of increased difficulty, the increase in detection time and error rate is inevitable. Under the current flow operation mode, the abnormal occurrence of the first detection will inevitably affect the operation of the entire production line. Especially in the case of frequent wire change, each change must be carried out a first piece detection, at this time the detection efficiency will more affect the production.

There are many defects in the traditional manual SMT first detection, and the following detection report is a headache, and the manual report format is chaotic and data errors often occur. The first piece of detector will not appear such a situation, the system automatically collects test data to avoid various errors that occur when manual recording. After the test is completed, the system automatically generates the report, and can export the report in Excle format, which is very convenient for audit.